W140 Front Bumper Removal
 

I'm going to be pulling off the front bumper of my 93 SEL500 for painting and wasn't exactly sure how to pull it off. I'm sure I can figure it out, but if anyone has some good advice on how to do it properly with the most efficiency, I'd appreciate some good tips.

If I remember correctly:
1. Remove two small covers and remove temperature sensor from the left cover.
2 Remove 4 nuts - two behind the small covers and two directly above them in the lower corners of the grill openning.
3. Slide bumper toward front

When installing, slide bumper into lateral quides on the left and right sides. Adjust gap between bumper and fenders to ~5mm.