hello, i'm looking for some help rationalizing how much work to put into my 88 420sel.

i bought this car this time last year. soon after the motor started the awful lifter noise. so i left it to sit till i slowed down enough for some time to fiddle with it. what it ended up being is a rocker arm got lunched on the right side. just one. so i'm committed to repair this issue. i bought a new cam, rocker, ball stud and vlv cover gskt.

now here's the question. 1st the car really is cherry. excellent interior, everything works, runs super. and i got 6k in it now. now i need a car that can be a daily driver as well as looking good for guests when i call on them. now i was planning to just fix what was wrong. however i keep eyeing the chain assy mostly the plastic parts. i mean i am right there and it wouldn't cost me much except another 150 bucks to do a new chain and all the plastic goodies. i really need a nice car without the cost involved. i just ran my 98 merc grand marq into the ground value wise at 90k.

i figure i could ride another 100k on this mb 420sel and all it would cost is the 6500 i would have in it. so with all this information......

should i replace all the ball studs (i own the special vlv spring tool and the height check) and maybe the cam even though it is now looking just fine. i've read a few comments of this happening on the 126's due to poor oiling. so should i expect the non replaced parts to last another 100k miles. the oil pressure is super the car rides good with no bad tire wear noticable.

part of my indecision is the xtra 260 bucks but it will add quite a bit of time to the job.

if i fix the top end and the timing chain, can i expect to see 100k more from the bottom end i.e: block / pistons & crank.

it was a southern car so there is no visable rust but who knows about the little crevises and what is hidding.

any advice is welcomed.
tks much
craig

this forum is probably the best source of info i have ever seen for depth of knowledge and on point of issues.

here is my other mb '72 350sl red w/black int

Attached Thumbnails

 

__________________
Thanks Much!
Craig

1972 350sl Red/Blk 117k
1988 420sel charcoal/Blk 140k
1987 420sel gold/tan 128k
See My Cars at:http://mysite.verizon.net/res0aytj/index.html

Pound it to fit then Paint it to match!

There is only First Place and Varying degrees of last!

Old age and deceit will overcome Youth and Enthusiasm every time!

Putting the square peg in the round hole is not hard... IF you do it fast enough!

Old enough to know better but stupid enough to do it anyway!