Test 7.3-1633 Anybody know where I can get the procedure?
 

I have the W124 CD but other than identifying the test, I cannot locate it on the CD.

What do you want to test??? I'm guessing CIS-E ???

I dismantled my fuel distributor. The shaft for the air deflector has two electrical contacts that connect to the black box three prong connector on the front of the fuel distributor. I have seen the test for value but cannot remember where it was.

Do you mean the air flow sensor?

Yessir I do. I suspected a leak at the plunger seal and dismantled the unit without benefit of training. Only after complete disassembly did I realize that I didn't need to remove the shaft. Now I have the formidible task of recalibrating this sensor.

Cap'n,
 

I just went to the same problem. In case you have not read this threat:
http://www.peachparts.com/shopforum/showthread.php?threadid=55589

You calibrate the fuel distributor to the sensor, NOT the sensor to the fuel distributor. It has to do with screw adjustment.
I hope this helps!:cool:

This is the sensor I'm referring to.

And the two prongs on the airplate sensor shaft.