|
|
|
|
|
#1
01-14-2000, 11:24 PM
|
|||
|
|||
|
I have rebuilt both Zeniths on my '71 250C and am looking for information on how to re-set the "travel" on the secondary diaphragms. Both have been replaced and I measured the number of turns it took to remove the diaphragms, but I just want to make sure that they are set correctly.
|
|
#2
01-17-2000, 10:01 AM
|
|||
|
|||
|
I checked the Zenith carb adjustments manual. No information is given about the rod length, just how to check and replace the diaphragms. It looks like the diaphragms used to come with the rods on them when this manual was published.
------------------ W.R.Durrance ASE Master Tech Mercedes Tech 19 Years
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Vacuum help? | kerry | Diesel Discussion | 14 | 01-04-2005 05:01 PM |
| Erratic Vacuum | MicroRacer | Diesel Discussion | 0 | 04-04-2004 03:06 PM |
| Climate Control/Vac Leaks | diesel don | Diesel Discussion | 16 | 11-10-2002 09:16 AM |
| 82 300TD A/C problem | benchracer | Diesel Discussion | 15 | 06-16-2001 08:50 PM |
| Door lock diagnosis & repair, by popular demand | ncarter | Tech Help | 1 | 07-15-1999 10:24 AM |
Linear Mode
