'91 190E front flex disc

[OKC190]

I was looking at the front flex disc last night trying to track down a vibration. The bolts on the disc were loose, allowing relative movement between the flange and the disc. Can I just tighten the bolts, or is it time for a new one? Car has 115K miles on it. Thanks

------------------
Ted Beer
'91 190E 2.3

[jeffsr]

Definitely replace the rubber coupling. Also check the bolts and the retainer nuts. (they should be replaced anyway as they are designed for a one time torque down.) If the bolts aren't damaged, they can probably be reused. On some models, there is an alignment pin in the center of the output flange which mates with the driveshaft. There is a bushing or bearing in the center of the driveshaft that this pin mates with. You should probably replace that as well. Check the alignment pin for excessive wear also. I believe that model has a two piece driveshaft, so if you are comfortable working on it go ahead, otherwise, give it to a pro.
Good luck..

------------------
Jeff L
1987 300e
1989 300e