Quote:
PhantomZX said:
I was able to remove the bolt by putting a socket with breaker bar over the bolt, resting the end of the breaker bar on the ground, then jabbing the starter. Would that work on these engines?
|
On these engines the bolt is torqued to 450 ft-lbs. I was able to break a socket using this technique, and I won't try it again!! You need two breaker bars; one holding the balancer itself, braced against the frame, and the other on the bolt, with at least a 5-foot cheater bar unless you're really built. I got a Craftsman (Ingersoll-Rand) 600 ft-lb impact driver just to do this job. It was not up to the task.
10-28-2003, 08:51 PM
Threaded Mode
