|
|
|
|
|
#11
02-26-2000, 10:20 AM
|
|||
|
|||
|
Repair manual does not call for preload, just good straight alignment. I have not been able to find anything related to skewing the carrier to achieve preload. It should be installed perpendicular to the long axis of the vehicle. I believe these are tapered race roller bearings, so if you must preload, make sure the small end of the taper is in the same direction you are loading to, otherwise, you will really help the bearing to disassemble itself further down the road. Just put it in lika da booka saysa to doa.
------------------ Jeff L 1987 300e 1989 300e 1987 BMW 325 
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| tranny removal (drive shaft) | almadroog_7 | Diesel Discussion | 3 | 08-27-2004 07:46 AM |
| 1983 240D trans replace--How do I get the Drive shaft back on?? | Carrameow | Diesel Discussion | 4 | 12-17-2003 01:27 PM |
| 240d Play in center bearing and thumping over bumps | NC240D76 | Tech Help | 1 | 01-16-2003 05:59 PM |
| U-joints - center bearing clunk | djwhite | Diesel Discussion | 10 | 06-06-2002 11:54 AM |
| changing center bearing | fryerpowered | Diesel Discussion | 2 | 12-21-2001 09:32 PM |
Threaded Mode
