|
|
|
|
|
#1
03-15-2000, 11:16 AM
|
|||
|
|||
|
This one is for Benzmac. I'm having the head done after the blown head gasket. It has been disassembled, cleaned, waiting for valve guides, etc. Question..When the head is reassembled, is there a way to prime the lifters without having to disassemble the valve train again. In the old days, we used to crank the engine without the plugs in until a readable oil pressure was evident, put the plugs back in and finish the job. Is this something I can do with these tiny little lifters or is there another alternative that I am not aware of??..
Thanks Jeff L. ------------------ Jeff L 1987 300e 1989 300e 1987 BMW 325 [This message has been edited by jeffsr (edited 03-15-2000).] 
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wagon rear suspension valve rebuild | lrg | Diesel Discussion | 11 | 10-04-2006 06:02 AM |
| Valve cover gasket replacement – 95 E320. | 71Rcode | Tech Help | 0 | 03-10-2004 08:44 PM |
| HLC hydraulic lifter tool & valve spring compressor | gedeonbgjr | Tech Help | 4 | 06-23-2003 11:37 AM |
| Benzmac, Steve, someone, please share how an idle control valve fails. | Tinker | Tech Help | 37 | 07-15-2002 01:01 PM |
| unsteady valve clearances | jerryrigged | Diesel Discussion | 5 | 01-24-2002 09:55 PM |
Threaded Mode
