om 617a help
Hi, just need a little advice on reassembling my om617a (from an early 80's 300 turbo diesel). I can't find any starting point for locating the injection pump sprocket relative to TDC when installing a new timing chain. I had difficulty getting the chain out and in a dumbass move rotated the sprocket and didn't punch a ref. mark. Also, is it extremely difficult to rebearing and seal the turbo? Apperantly the engine (allthough low miles) was run upside down starving the crank(replaced) and turbo(rebearing due to excessive radial play?). I can't detect any other damage. I am swapping it into my Unimog, and my experience with diesels is weak. Any other thoughts and advice is appreciated.
PJL |
here we go
do a "timing injection pump" search on here. You will need to remove the injection pump. Once you do it you will be amazed at how simple it is:).
|
turbo
Any ideas on redoing the turbo? I can move the compressor over far enough to bind on the housing approx .010"-.020" using the thumb dial gauge.
PJL |
|
All times are GMT -4. The time now is 12:17 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website