PeachParts Mercedes-Benz Forum

PeachParts Mercedes-Benz Forum (http://www.peachparts.com/shopforum/index.php)
-   Tech Help (http://www.peachparts.com/shopforum/forumdisplay.php?f=1)
-   -   300DT '87 won't start after fuel filter change (http://www.peachparts.com/shopforum/showthread.php?t=80779)

danarubison 11-30-2003 03:34 PM

300DT '87 won't start after fuel filter change
 
My first posting; thanks all for your help.

I changed both fuel filters on my 87 300DT and about 12 inches of fuel line that looked tired. The car, which was running fine prior to the maintenance, will no longer start. I have cranked it for many minutes hoping to bleed the system without any results.

The prefilter is clear, and it is full of fuel.
When I remove the banjo bolt from the line from the canister style filter to the injection pump, diesel comes out.

I have place this line in a cup and collected fuel with cranking, though I have not measured the flow rate.

The fuel came out, rather than shot out.

There is no fuel emited from the injection into the hard line of the first injector.

I am puzzled about what is going on. Is the injector pump sensitive to the delivery pressure and volume of the fuel pump? I went as far as using a small transfer pump to squirt some fuel directly into the injector pump to try to see some activity, but there was no flow out of the injector pump.

Any help would be appreciated.

Thanks

jgl1 11-30-2003 03:58 PM

Check the fuse on the OVP relay, which is located in the electronics bay behind the battery. If the fuse is blown, replace it. Or the relay itself may be defective.

Alternatively, the injection pump fuel return line check valve, located on the right side of the injection pump, may be faulty.

sixto 11-30-2003 05:20 PM

This seems to happen only to me but maybe you're the second in a million - is the stop lever stuck in the down position?

Next thing I'd do is crack all the injector lines to see if any get fuel.

Sixto
95 S420
87 300SDL
83 300SD ... $1100, see cars forum

psfred 11-30-2003 09:20 PM

If you didn't fill the fuel filter, the IP is now full of air. Takes a while to get rid of it at cranking speeds.

Try cracking all the injector lines at the injectors (14mm) and cranking with the pedal to the floor for a while. This will help purge the air out of the pump. Be prepared to crank for a while, and to charge the battery at least once.

Once you get diesel fuel at the injectors, tighten the cap nuts and try starting. You should at least get it to kick some right away. It will take a few minutes to run smooth -- takes a while to get the air out of the injectors.

I always change fuel filters with a hot engine, it will crank faster and start easier.

Peter


All times are GMT -4. The time now is 09:30 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website