|
|
|
#1
|
|||
|
|||
300E rear pillar trim
Does anyone know how the trim on the rear pillar (between rear
window and back glass). I assume there are clips in the trim that go into the frame but need to know which way to push the trim so I don't break any clips. Thanks. |
#2
|
|||
|
|||
The trim needs to slide forward to release the clips. They'll likely break anyway if your experience is similar to mine.
|
#3
|
|||
|
|||
Thanks Joe. Were you able to buy new clips or did you repair them? i.e. super glue?
|
#4
|
|||
|
|||
Actually the flat plastic panel that backs the inside trim broke where the clips attach. I was very careful and think the PO or shop had broken them previously.
The only way I could see to repair them (other than new) was to use a heavy epoxy on the inside. I didn't bother and they are staying in place fine. Good luck!! |
#5
|
|||
|
|||
Thanks Joe - I'll giv it a try.
|
Bookmarks |
|
|