|
|
|
|
|
#1
09-25-2000, 07:41 PM
|
||||
|
||||
|
I am about to replace the idle arm bushings in my 86 300E. According to the manual, it does not seem complicated. However, once you loosen the nut and bolt, it looks that there is not enough cleareance to remove the bolt and the exhaust may be on the way. Is there a easy way, tips or shortcuts to do this procedure, without removing the exhaust piping?
J.H. P.S. The whole front end is new. 
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1998 W210 Lower Control Arm Bushing Pix | phouse | Tech Help | 11 | 07-03-2006 09:44 PM |
| Front control arm bushing compatibility question..??? | J Irwan | Tech Help | 1 | 02-27-2004 01:14 AM |
| Font upper control arm bushing | MVK | Diesel Discussion | 5 | 07-04-2002 10:10 AM |
| Help Techs!! Control Arm Bushing Help Needed | 300EVIL | Tech Help | 2 | 03-24-2002 05:14 PM |
| Idler Arm Bushing Replacement | John Plut | Tech Help | 3 | 03-14-2002 12:54 AM |
Threaded Mode
