|
|
|
#1
|
|||
|
|||
Looking for valve cover brackets- M130
I’m looking for the three brackets that the valve cover bolts to on a m130 engine. Thought I had a small leak due to a bad valve cover seal only to pull the cover off and find that one of the brackets is cracked and another is pretty warped + has rubbed against the cam. All I can figure is someone must have torqued the cover down way too much in the past. Long story short- anyone have an old m130 they would be willing to pull the three valve cover brackets off of? Much appreciated!
|
#2
|
||||
|
||||
Guy in parts for sale section of his forum had a w108 he was parting out. Maybe he’s have what you’re after.
|
#3
|
|||
|
|||
I’m not sure I have them, but do have a w108 250s with dual zeniths I am parting out. I think it is a 1966 or 1967 model.
__________________
Past mb: '73 450sl, '81 280slc stick, '71 250, '72 250c, '70 250c, '79 280sl, '73 450sl, parted: '75 240d stick, '69 280s, '73 450slc, '72 450sl, |
#4
|
||||
|
||||
They are all the same width. There may be a slight different in height between the M180, M127, M129 and M130. There might also be a slight difference in the bend pattern.
A photo and a measurement in mm should be all it takes to resolve the question. -CTH |
Bookmarks |
|
|