View Single Post
Old 07-24-2001, 11:36 PM
Stan Pittman Stan Pittman is offline
Senior Member
Join Date: Apr 2001
Location: Beech Island, S.C.
Posts: 468
Remove the brake caliper, remove the locking wheel bearing nut using a 5MM allen then remove the hub and rotor. Put the rotor in a vise and remove the 5 10MM allen screws. Reverse the order to install. It's a good idea to clean and repack the wheel bearings at the same time. When tightening the wheel bearings use a feeler gage and allow .004 clearance between the nut and the bearing.
Reply With Quote