What I've done is listed below. Not all work was 100% necessary, I just want to make it as like new as reasonably possible.

Work done immediately prior to purchase by seller:
A/C blower motor
oil sending unit
driver’s side door window motor
Climate control unit

Work done by me: (January, February & March of 2006)
Coolant reservoir
coolant reservoir cap
5 coolant hoses
thermostat & gasket
radiator overflow plug
coolant
Acc mono valve
auxiliary water pump
grommets for windshield washer tank pumps
fuel filter
oil and oil filter
power steering fluid flushed & filter
hydraulic fluid flushed & filter
transmission fluid, filter, & gasket
rear diff. fluid
wiper blades: front, back & headlights
distributor cap, rotor, suppressor & o-ring
ignition wire holder
6 spark plugs
voltage regulator
battery & battery hold down clamp
refinished battery tray
2 breather hoses
air intake hose
hood silencer pad
rear muffler & muffler clamp
4 exhaust system hangers
flushed brake system
flushed hydraulic suspension system
adjusted front bearings
rear shock bump stops & shock boots
2 accumulators
suspension Pull Rod
adjusted ride height
replaced trim piece by front seat

rubber covers that attach to driver's side & passenger mirrors
Acc. belt idler pulley
fan clutch bearing bracket
rear hatch stabilizer shocks-2 & new pins
re-glued MB tex in front side pockets
support joints on rear wheel carriers
valve stem seals
valve cover gasket
strut mounts
power steering hoses low pressure 2
hydropnematic suspension hose
air filter housing mounts
4 electrical connectors 0115457128
brake hose to calipers all 4
A/C system: receiver/dryer, pressure switch, temp. switch & 2.204 lbs of R134a
replaced all small vacuum hoses and rubber connectors in the engine compartment

Thing I’m going to do:
Install new a-arms with new bushings and ball joints
Install new front swaybar bushings
New tires and wheels