OK ,so i removed pump yesterday ,marks were align perfectly so conclussion chain never skipped, problem is the cam ... by the way you cant just turn ip 180 degrees when turning it has 4 stages , similar to the camshaft with valves; so after each one it jumps ,theres no smooth movement.
What i did i just align marks -crank was at 24 ,i rotated engine 360 so crank again 24 and cam lobes now pointing up...reinstalled pump....result-0
Engine doesn't start .
This morning went back and rotated camshaft 180 degrees , by removing cam towers for #1,#2 cylinder (time 1hr install /reinstall ,compare to 4hrs on IP) ,
result engine started right away but performance worsened,
tried to time IP no luck ,again fuel flows only on exhaust stroke ,at compression stroke 0 , but this time fuel flows when pumping primer pump,no dripping ,now im really confused , im back to were i started with worst results,all suggestions are appreciated.