Quote:
Originally Posted by P.E.Haiges
dunl,
Wire the torq converter (TC) to the bell housing so it doesn't slip off the shaft and install TC and trans together. Then snip off wires and remove them before U push the bell housing (BH) home .
|
My torque converter (finally figured out which piece that was) seems to be on there good and tight, but that might not be a bad idea.
Quote:
|
I don't understand how U got the 2 top bolts out of the BH with a 3 inch extension. My bolts in so tight, I had a hard time getting them out with extensions.
|
Simple.
I'm a hulking 150lb soaking wet monster.
