View Single Post
Old 01-29-2002, 08:42 AM
Posts: n/a
27 mm bolt on crank W126 500 motor

Any tricks to removing this bolt other than a half inch air gun and 125lb pressure. I tried a large bar and pipe with the flywheel jammed and CANNOT budge it loose. This is the spare engine sitting on the ground. If I can't get it off on the ground, I am afraid I will never get this bolt off on the engine in the car. Any help or suggestions greatly appreciated. If I get the bolt off, where do you get a puller to pull off the thing that the bolt is holding on? Thanks, guys. Woody
Reply With Quote