I'm updating this thread finally because I've just managed to do this job today. I know I'll have to bleed the system and I've been reading up on how do do so and frankly I'm at a bit of a loss. The brake pedal hisses and goes easily to the floor, but it does stop the car from a push roll in the parking lot. The clutch however just flops to the floor and I have to pull it back. So I'm sure I'll have to bleed the clutch but how? Is the cylinder on the inside of the firewall that the braided clutch hose goes to the master or slave cylinder and how do I bleed it? Do I unscrew the bolt at the bottom of it and let fluid just run down from the reservoir or what? I'll have to replace the braided hose as well as it's leaking fluid out badly now as well. Didn't notice that before I did this job. This week has gone from bad to worse and I'm almost at the point where I'm about to junk this car. I just don't know if I can take anymore.

- Peter.

__________________
2021 Chevrolet Spark
Formerly...
2000 GMC Sonoma
1981 240D 4spd stick. 347000 miles. Deceased Feb 14 2021
2002 Kia Rio. Worst crap on four wheels
1981 240D 4spd stick. 389000 miles.
1984 123 200
1979 116 280S
1972 Cadillac Sedan DeVille
1971 108 280S