Quote:
Originally Posted by P.E.Haiges
I use go-nogo gages. Intake: .003" go and .005" nogo. Exhaust: .013" go and .015" nogo. I always set them to the high side.
P E H
|
are those numbers right?
a chart i looked at says .0118"=0.3mm, and .0039"=.1mm
if I read this correctly, your exhausts are on the high side, and your intakes are on the low side.
I did mine in mm, which i took as .1mm intake and .3mm exhaust (no turbo)
I also assumed the next size up should be a no-go.
but since I still am running kinda rough, I do wonder if I am wrapping my brain around those clearances correctly...
