Quote:
Originally Posted by Stevo
I have to make a new set as I used "chepo' wrenches and one has spread to 15+mm eek:. Did you use just a propane tourch? Oh crap, the lights are flickering  |
I used a cutting torch (acetylene and oxy) for a few seconds and bent them as directed in the archives of this site. Not good enough with a computer to direct anyone to that posting - but if I can dig it up, anyone can. Note that the orientation of the jaws of the wrenches are opposite. It was still difficult for me to work around the injector lines.
Also, I found it a bit difficult to turn the engine with the power steering pump alone. But with a little pull on the belts plus a wrench on the power steering pump, it wasn't too difficult.
Thirdly, I found it easier to make a drawing on a sheet of paper and adjust the valves as the cam brought them up, rather than working front to back. Just gotta make notes and keep distractions to a minimum