Thread: Use of Go-No-Go Gauge for Valve Shim Replacement
View Single Post
  #7  
Old 01-15-2009, 10:56 AM
mbboy mbboy is offline
Registered User
  
Join Date: Jun 2008
Posts: 475
Quote:
Originally Posted by M.B.DOC View Post
To start with, MB used several sizes to adjust valves from factory. MOST were around 4.8-5.5mm.

You do need an assortment of shims! So order at least 4 of each size below 4.8mm, of course measure all of the ones you have to start with.
Then the fun begins.

Thanks, Doc. I don't know if I lucked out -- or what -- but when I tested the rockers yesterday, all of them were perfectly centered on the gauge's measuring line.So, hopefully, I won't have to re-shim them after all.
Reply With Quote