Quote:
Originally Posted by JonL
3. When you remove the IP and set it so the tang lines up, you will need something to hold in position when it is installed. There is a special tool that goes into the port and engages the tang to hold the IP cam in the right position. I made a tool to do this, but once again... there's that whole paperweight issue.
|
I apologize...........you've clearly proven your mettle with regard to the knowledge of these engines.
I have the tool to do this and I've never been successful in using it. Apparently, two people are required to prevent turning the IP notch right through the very tiny notch in the tool.