Thread: zenith carbs
View Single Post
  #3  
Old 10-03-1999, 10:01 PM
metricman
Guest
 
Posts: n/a
To start, I would disconnect the linkage between the 2 carbs, to be sure they are both at the throttle stop. Also, there is a small hole in the casting on the top of the carb, at the base of one of the 'bulges' that is the idle air bleed hole. I remember plugging that hole with my pen tip, and if the idle did not change, then the top of the carb is warped (some one overtightned the air filter housing wingnuts.

Good luck...

------------------