Finally found some mount arms that will work. I have to make some spacers to get the spread right but the foreward and height is good. They are from a m111 in a c class. I still have to make a trans mount and get a new drive shaft but the hardest part is figured out. I will post some pictures. I was thinking of using the springs from the 230e cars as the engines probably weight close to the same.
Does anyone have the weight of the om617, 0m602, m102 engines handy.
I am super excited about this setup with the 722.6 with overdrive. I am probably going to install a 2.8 rear end to get the engine revs lower.