Quote:
Originally Posted by rs899
It has been awhile since I had my hands on the K1 clutch pack, but I would say that if you don't get it home and seated, your input shaft will not turn. I don't recall any tricks, but I do recall that it was a PITA.
Hmm, I don't recall the bearing, and unfortunately I trashed all my pix of the disassembly...just last night
If you make it a multiple choice quiz with some pix, I might just remember (or maybe not). Or.. call the guys at JIE.com..they will know for sure.
Rick
|
Thanks Rick. After fiddling with it for about four hours it finally went in---I used the polish mark from the brake band and the brake band to verify it had gone down as far as it could.
I did some more digging and figured out the bearing thing so all is good---I hope *crosses fingers*. Tomorrow will tell