Quote:
Originally Posted by jmann.arch
Thanks Brian - will check that tomorrow!
It definately could be the CCU - my first repair on this was the blower not working. I have the original blower motor, think it needed oil (was squeaking) it killed the regulator, and melted the housing for the single fuse for the blower motor. I replaced the regulator, and fuse and got the blower functioning again. I oiled the blower with wd-40 and got rid of the squeak, but I have noticed it coming back particularly at low speed. I think I am going to go on and replace it, unless there is something that will work tons better on oiling the bearings.
|
this is not oil.
it a very mild rust dissolver, and solvent.
you need to open it back up, and put some light grease, or oil on the bearings.
WD40 evaporates very quickly, and it attracts dust that will eat the bearings and the shaft.
get it out of there! I'd clean it off with electrical contact spray or brake spray, and dry it well, then pack it with light grease/wheelbearing grease.