Thread: OM60_series IP delivery valve reseal
View Single Post
  #28  
Old 07-02-2010, 02:27 PM
whunter's Avatar
whunter whunter is offline
Moderator
  
Join Date: Dec 2003
Location: Metro Detroit, Michigan
Posts: 17,432
Data.
Quote:
Originally Posted by gsxr View Post
1) Good.
2) Yes.
3) It can move around, but when you re-install the holder, it must be centered to allow the holder to screw in place.
4) It just lays on top of 7g. Use a small screwdriver to get 7g and 7f mostly centered before re-installing the main holder (7).

Don't forget to use the 3-stage torque procedure, which is not mentioned in the 602/603 FSM, it's only described in the TDM (Technical Data Manual) and 605/606 FSM. Tighten to 30Nm, release, 30Nm again, release, and then tighten a third time to a final torque of 35Nm.

See the "Installation Note" on page 2 of this PDF file:
Installation note:
To ensure that the seals of the delivery valve holders are correctly located, tighten the delivery valve holder to 30 Nm and slacken, once again tighten to 30 Nm and slacken, and tighten finally to 35 Nm.
Last edited by whunter; 01-28-2011 at 02:33 PM. Reason: removed dead link
Reply With Quote