Quote:
Originally Posted by Yak
How about a good pic of the inside of that cover plate?
I just checked my Harrison HR100T that was not OE, but may/may not have been an M-B repair and compared to the CompressorWorks. The Harrison has the X/casting on the top, as installed, and the CW will be on the bottom.
Is there some hole or channel on the inside of the cover? Mostly hemispherical?
|
I am out of town and won't be able to take pics till Saturday or Sunday. The hole is on the inside of the cover plate (with 4 bolt holes) right above the needle bearing/ seal. If the orientation of the hole is wrong, you can re-orient it by removing the 4 bolts and pulling the cover. I used a 3/8 breaker bar to tap it off but there must be a special puller for it.