|
Only if switched off by the high or low pressure switch, I believe.
Have you done any testing of what the interior temp is, up near the dome light (where the interior temp sensor is located)? Could also be a fault with the evaporator temp sensor I suppose. Shoul dbe blending air to get proper temps. What do you have the temp set at, or just always cold? Would be interesting to watch for a change in discharge temp if you try setting the temp, lets say at the lowest temp (60?) and then try it at say 75 degrees.
OH alos just caught what you said about "fan in the lowest speed", I would also try doing some testing in the "AUTO" mode and not adjusting the fan speed at all, let it run in auto and see if the fan slows by itself. There should be some tutorials on the site or on the web somewhere that shows how to get in to diagnostic mode and check some of the input readings.
Gilly
|