Trying to figure out a high-idle, low-idle issue on a 1991 manual trans 300SL, described in another post. There is a suggestion that a fault in the ignition control module may cause this. If so, the ECU will store the fault in memory which can be accessed via Pin 7 on the 55-pin cable to the ECU.

In the Alldatadiy and Mercedes documentation, there is mention of a 9 pin X11/4 connector on the left inner fender, which this car has. However, there is no connection from any of the pins in that connector to Pin 7 in the ECU cable (supposed to be to Pin 3).

There is also mention of a 14 pin L-shaped X11/4 connector in the control module area on the right side. But unless I'm missing something or going blind, it's just not there.

So, any ideas where I can find the connector to hook up my impulse counter and see if there are any faults?

Thanks,

__________________
Chuck Taylor
Falls Church VA
'66 200, '66 230SL, '96 SL500. Sold: '81 380SL, '86 300E, '72 250C, '95 C220, 3 '84 280SL's '90 420SEL, '72 280SE, '73 280C, '78 280SE, '70 280SL, '77 450SL, '85 380SL, '87 560SL, '85 380SL, '72 350SL, '96 S500 Coupe