I did some re-testing today! 1. Continuous Fuel Injection using socket #3
I continued to get just 1 flash. I then pulled the coolant temperature sensor & started engine for a few minutes. Then I checked it again & I got 3 flashes. So, I cleared it out. Then I tested 2. Continuous Fuel Injection (MAS Controller) socket 14 I got code 4. Output for oxygen sensor heater control defective
& code 6. Output for kick down control defective. So, I then reset all the registers. I drove it a few times today on short trips, & then I did a follow up check. I didn't show anymore codes on either socket after that. I wasn't for sure if trouble showed on the MAS Controller socket if that meant it was bad or just related to the different components, as well? I wasn't for sure on the fault codes which ones pertain to the Crank or Timing sensors?