No, but it would be SUPER easy to make and pretty cheap to have made if you don't weld. Go find the correct size tubing and let the welding shop cut and weld the plate. Probably no more than an hour of shop time.

That said, I assume that you are using a floor jack. If so you can throw a floor jack just inboard of this point at the rear. There is a beam that runs the whole fore and aft on each side beginning with the front turn up rails all the way to the rear fender opening. You can put it in there about anywhere with no worries. To lift the front, place the jack under the most forward FLAT section of the turn up rail.

__________________
2001 SLK 320 six speed manual
2014 Porsche Cayenne six speed manual

Annoy a Liberal, Read the Constitution