|
We had very bad weather and strong wind had holes under the nylon, so my motor is all full of sand. I have to clean it with
water jet pressure. I have to remove oil pump and oil filter container. Is it difficult to do?
Do i have to be careful about some details?
And.
As You may see on attached picture i have another problem.
And it is just under the IP. So i have to remove it also.
( so.... i have to do think which has i more afraid of,...., but i had study the problem and i'm prepared)
Ok my question is will it be sure enough if i just hit it with hammer to drive it back into the hole.
I have no idea how this happened. And i had no water in motor because it was at peaces. So this should happened winter before this one and when engine was stand still and ice broke it out. So this could be the reason of my troubles. Why i had water loss and why the engine overheated.
|