>>>Assume that you used the little ring-like gaskets when you hooked up the exhaust. Best way to check for leaks is to hold your hand by the manifold-downpipe joint when the car is first started and the pipes aren't hot.
Brand new ring gaskets..but I'll check for air movement today..
>>>Now is the time to get the dwell right. If you set the point gap at .012" it will be close. Then time it to around 8 deg btdc w/o the vacuum.
Okay I'll try that too.. So I disconnect both vacuum lines from the distributor? BTDC would mean the 0|0 mark will move towards me right?
>>Also make sure you have no vacuum leaks - all fittings on the intake manifold and carb either used or plugged.
New gasket on manifold.. what do you mean by plugged???
__________________
MB 72 250 M130.923 114.011 170k The Beauty
|