From member rcounts: "On this style the tach gets its signal from a different sensor mounted at the BACK of the engine in the bellhousing of the transmission - just behind and below the bottom of the oil filter assembly. The sensor is held in place by an allen-head screw and it takes a 5mm allen key to remove it.

My sensor is bad and needs to be replaced. You can test it by unplugging the 2-wire cable connector at the center of the hood opening just in front of the cowl. If you follow the wire from the sensor up to the connector it is easy to find.

With the car off, connect an Ohm meter to the two make pins of the cable connector. It should measure 1.9k Ohms +/- .2k ohms (that is 1900 Ohms +/- 200 ohms). If that measures OK, then start the car and use a volt meter to measure the voltage across those same tow pins. At normal idle speed of 750-800 RPMs it shoud measure ~4V +/- .1V.

If EITHER of these measurements is outside these value ranges, it needs to be replaced. "