View Single Post
  #1  
Old 01-08-2013, 02:34 AM
aspireelectronics aspireelectronics is offline
Registered User
 
Join Date: Jan 2013
Location: la calif
Posts: 18
1987 300e start then stall

Hey guys,
This vehicle was towed in a no start,it ran fine the nite before.
After adjusting the the co% at fuel dist I got the vehicleto start
But stalls n jus seconds,will run as long as u spray eithe
... Also if you leave the key n the start position (overrun) starter
Runs till released.an has batt voltage at dist all the time key is on
Jumped pin 7 & 8 pump runs replaced filter was clogged
Wen depressing air meter plate all four injectors spay ok did visual
Engine jus cranks wit pins jumped. Noted 79 psi.on fuel gauge
But adaptor leaked.parts replace (used)3 ovp,2 fuel relays,1 cps,
2 fuel dist,1 ign module,1 eha original leaked,drained fuel.was
Dirty, laid all six plugs in wires on exh manifold.fat SPL on all on tim
Replaced both iac hoses,1 cold start valve.vehicle will only run forr
Couple seconds,anti_loc lamp off while running.pumpturns off after engine
Stalls, I DID NOT REPLACE FUEL COMPUTER YET. Vehicle starts then stalls.
Any suggestions appreciated.
Reply With Quote