The following instructions are copied from the original poster (babymog) and photos supplied by me(TheDon)
tools used for the most part
1) Remove screw-cover from RH speaker grill, small strip toward the center of dash, by prying upward along the length. Don't reach too deep to pry or you'll get under the speaker enclosure, and be careful not to damage the dash by prying. It can usually be removed with a strong set of fingernails.
2) Remove two small phillips screws from speaker grille.
3) Rotate/lift the speaker grill up and toward the A pillar, slide the clips on the A-pillar side out of the dash.
4) Remove the 8mm bolt exposed by removing the grille.
out come of steps 1-4
5) open the glovebox door and remove the 6 retainer buttons (top and bottom) by prying the button out ~1/8" and then pulling out with fingers or needle-nose pliers. If the clip doesn't come out with the retainer (2 pieces each) you will have to pry the clip out separately.
the clips can be a bit hard to remove, try not to damage the felt liner
6) Remove two phillips screws and glovebox latch from top of the compartment.
