Quote:
Originally Posted by Stretch
The injector heat shields should be replaced every time you remove and replace the injectors - these are a fit only once part.
If you don't fit new ones then the chances of a good seal is somewhat diminished...
|
Indeed, it looked like they were there, normally I remove them by hand before turning the motor over, because they fly into the air. I even sliced a bit out of the side of a screwdriver to try and remove one, no budge.
I can't remember what the hole should look like without a shield in it though, does it look similar to a shield ? as in with a circular "step", or is it just a concave surface with a hole ? I'm guessing the second option.