Quote:
Originally Posted by Stretch
Any chance of a picture of the tool in action?
It doesn't do the pinion position does it?
|
I am not to the point where I can take a Picture and when I looked I on the Internet I did not see one of it in use. There is a small pic in the Manual.
You stick it in where the Shim Pack would go on the Differential Carrier.
It may or may not be helpful with the Pinion and Ring Gear Back Lash.
I don't think it would be helpful for that because the Carrier, Bearings, Spacer, and Shims all need to be in place and the Bearing Caps torqued in order for the Backlash to be accurate.
There is several Tools in the Pinion depth Tool kit to figure out which Shims go behind the inner Pinion Shaft Race.
However, I am not changing the inner Pinion Bearing or the Pinion and Ring Gear so that should already be set.
I am replacing the Outer Pinion Bearing set. But, that will not change the Pinion Depth.
Here is a used Tool the same as I bought sold at $175.
http://www.penybonttools.com/apps/webstore/products/show/2624401