Quote:
Originally Posted by ioang26
Well...what I have tried was to swap it with another used EZL but no change at all.
|
I just replaced the EZL with another used one from ebay and the car now will run without stalling.
But the next issue is still standing:
The engine would run only if the mixture is over enriched,in other words I adjusted the air plate to where there is no free play .
If I did leave the recommended gap of 1-3mm between the FD piston and plate the car would not start.
The EHA shows 10mA when measured at idle.
Any suggestions?What is causing this?