Man time flies by when designing! It wasn't too long ago it was 8:00P.M.

Anyway, like y'all's opinion on this. My preference is not to have barb fittings, as leery of them popping off. Further, the external cooler be mainly due to me burning up the clutches, and don't want to do that again. Figure when it gets below 64*F then use cardboard to block the cooler?

So, is both sides of the transmission hose the same size?

Supply (driver's side) hard line, 16mmx1.5 to AN6 adapter, braided high pressure hose (braided to protect against the belts), AN6 to 3/8"NPT on the external cooler. Then the fluid goes through the cooler. AN6 to 3/8" adapter, AN6 hose, 16mmx1.5 to AN6 adapter on internal oil cooler. The fluid then goes through the internal oil cooler, so as picks up engine heat, allowing the transmission to have proper, quick, warm up.

__________________
Current fleet:

1985 Mercedes-Benz 280TE - Waiting for heart surgery.

1985 Mercedes-Benz 300TDT - Rear ended 23 September 2016 and now looking for a new home.

1979 Mercedes-Benz 300TD - Parted out.

1964 Volkswgen Beetle - Vater's since September 1968 and undergoing a restoration.

1971 Volkswagen Sunroof Squareback with F.I. - in need of full restoration.

1971 Volkswagen Squareback automatic with F.I. - Vacationing with her caretaker until he is in better health.