I think you guys get the picture of my problem yes I am referring to the gear on the starter that is not engageing the flywheel. It is strange in that it never did this before I noticed that I was missing my top bolt of the starter a little while back when it would not start but think that was due to a lose ground strap any way ever since I did replace missing mounting bolt it started not engageing. I am thinking what might be the problem is that when the 1 bolt was missing the starter wore in the slightly cocked position it was and when I replaced bolt it put starter in a slightly straighter position and now I am having problems. I might try to loosen top mounting bolt to put in former position and see if problem stops or pull starter and closely examine , clean , and lube shaft that bendix goes in and out on to engage flywheel. On the NSS issue I think the junction box for the wires from it are somewhere behind carpet to the right of gas pedal I think that would be easier to get at rather then the switch itself. Thanks for all the replys I value them all.