Quote:
Originally Posted by bricktron
you rebent the 1985 .951 line to fit a .952? this line appears to be more than an inch too short. working with no mandrel, i'm not sure it would work. maybe heated up with a torch and with several new bends.
|
If you heat the Tubing you are going to cook and loosen the Oil residue that is coating the inside of the tubing and it will be difficult to clean out because the turbo end has like a 2mm hole in it which is much smaller then the tubing. That would make it hard to run some sort of brush in side.
Any sort of loose residue inside of that tube is going to go unfilterd into the turbo charger.