|
The cover plate for the governor
Grease up the sealing ring and the area where the ring goes in..
Put a little grease on the edge of the governor seal cap..It will slide in place easier and keep the o ring from rolling out of position..
Snap the c clip ring in place..
From the inside of the tail housing area, you can see the cap..With a long screwdriver, press the cap outward to have it tight to the c clip ring..Keep it from rubbing on the spinning governor that way..
So in the last picture you see the governor in..The governor retainer in it's proper place..drive gear for the governor installed on the output shaft..You install this drive gear after that c clip ring is installed on the output shaft shown earlier..remember?
And also the spacer ring (mine was .5 mm..20thousands)..determined in the step showing the thrust set up for the output shaft
Lets keep going..
__________________
1978 300SD 303400 miles
1983 300D 341270 miles
1980 300SD 320456 miles
|