Thanks everyone! I crawled under the car to layout a plan, after pouring over the FSM many times...overall it doesn't look too bad of a job, of course I haven't started to remove anything

After the advice from babymog I will replace the flex disc, as it has a few very small cracks. Nothing I am worried about, however the stress put on it from lowering the diff might do some damage to it (thanks babymog) so I'll just replace it.

First, I'll remove the flex disc, but not install the new one yet.

Next, I'll remove the mount toward the front of the diff (will replace as well).

Then, then I will remove the two bolts attached to the mount and slowly lower the diff using a jack and block of wood combo. I will lower it enough to see if I have acces to the mounts.

Next, use the special puller to replace the mounts.

Put her all back together and install the new flex disc.

Anything I am missing? There is the speed sensor attached, but I think the line is long enough to allow the differential to lower...if I remove it, will oil come out of the hole?

Thanks for all the help! This has turned into, what I think, s a manageable job!