Quote:
Originally Posted by 81TwofortyD
I had a set fabricated recently and just completed a valve adjustment on my 240D. Send me a PM with an address and I will throw mine in one of the $5 express envelopes for you to borrow.
|
Thanks so much for the offer. I ended up going with junk man's advice...
Quote:
Originally Posted by Junkman
FSM calls for fairly frequent adjustments. You may as well bite the bullet and buy or make some.
|
Bought a vice, torch and wrenches today. Just sitting down to do the fun part now.
The pelican DIY for the valve adjustment only says 22mm feeler gouges, but later says there are two gauge sizes, one for I the other for E. The closest I could find at my local parts place was 22.9mm, would this be sufficient? Can anyone confirm the two sizes I'd need?