Got the listed car (105k miles) in the shop with this code. Found #4 injector seal leaking and the beginning of black death. Took care of that and now I'm making an attempt to diagnose the low voltage fault code . I've checked the supply voltage to the sensor and it is 5 volts like it is supposed to be. On Autel items in error under the high pressure system is Fuel Rail Pressure Control Valve signal at 22.9% (range at idle is supposed to be 24-30)and Y94 Quantity Control Valve at 26.8% (supposed to be 37-42). I've narrowed it down to either of these two valves OR the in tank fuel pump. When driving the car I don't really see much movement on the quantity control valve position but that may be because it is in limp mode. Now the code will not clear even without starting the car. Prior to getting to this condition the car would run out good/strong when not in limp mode.

When the car first came in I was getting the code every now and then and these pressures were at 29.3% and 39.9% but the rail pressure was out of spec at 360 (min is 449 bar).

Has anyone run into this issue? Any thoughts/suggestions.

tia

__________________
Jim