|
I finally got some time to work on my project. I finished up the condenser mounting. It also appears that I have 3/16" of clearance on the fan. Its closer than I would like but I think it will be fine. I still need to check if the lower condenser mounts will fit on Samson. If not I may have to offset them further forward, which may make the fan hit. I did have to modify the cross bracing slightly because the lower center bolt would have hit the fan. It was an easy solution, just bend the lower tabs forward, drill a hole and nut and bolt it. The fan is just laying in place now so the rest of the weekend will be fabrication of the fan mounts. But so far I am very pleased, hose routing seams doable and I have room for the Receiver dryer.
|