That was one of the best, most informative posts I have ever read, Jim. It should be in a FAQ somewhere, as it completly explains the roll of grease in a bearing application, problems associated with it, and correct packing procedures. Bravo!

After reading that piece of art, I am going to pull my two "packed" bearings and try again. This time, I am going to soak the bearings in a solvent to clean them before re-packing. I will pack it to the brim, and give special attention to the assembly in which it will be working. Hopefully I can create a lubricating atmoshpere that will provide a clean, quiet, and cool rotation.

Thanks again, Cassidy